Setting Up Your HX Stomp

Let's take a moment and setup your HX Stomp to work with the Micro...

  • On the Stomp, press <Page and Page> simultaneously to open the menu
  • Press Page> and then press Knob 1 (Global Settings)
    Global-Settings.PNG
  • Turn the Upper Knob to select the Footswitches menu
    • Turn Knob 2 and assign FS3 function to Stomp 3 (this is only needed if you want to use fs3 as a stomp switch, you can choose not to do this step if you want to leave fs3 as tap/tuner

**** IF PURCHASED AFTER 4.24.21 SKIP THE NEXT TWO INSTRUCTIONS AND PROCEED TO MIDI/Tempo BELOW ****

    • Turn Knob 3 and assign FS4 function to Preset Down
    • Press Page> and assign FS5 function to Preset Up
      Footswitches.PNG
  • Turn the Upper Knob to select the MIDI/Tempo menu
    • Turn Knob 1 and confirm MIDI Base Channel is set to 1
      MIDI.PNG
  • That's it! You are all setup to start using the Micro

Revision #2
Created Fri, Nov 6, 2020 2:43 PM by Junior Thomason
Updated Wed, Apr 28, 2021 1:28 PM by Junior Thomason