Red Bank (Stomp Mode)

The Red Bank is where you will likely spend most of your time with the JET Micro. In this bank you can toggle blocks on/off, toggle effect parameters up/down, recall Snapshots, and scroll up and down presets. You can even setup one of the buttons to be an "always active" tap tempo if you wish, see "Global Settings" for details and how to set this up.

Each button has three time based press actions, which are a short press, double press, and long press.

        • Short Press - quickly press and release the button within 1/2 of a second
        • Double Press - quickly press the button at least two times within a 1/2 of a secondĀ 
        • Long Press - press and hold the button for at lease 3/4 of a second and then release

To recall Snapshots, simply do a long press of any button.

        • Long Press Button A - recalls Snapshot 1
        • Long Press Button B - recalls Snapshot 2
        • Long Press Button C - recalls Snapshot 3

Two button presses will scroll up and down presets. You can also hold down the buttons to fast scroll in either direction

        • Short Press AB - scrolls down presets
        • Short Press BC - scrolls up presets

To bypass blocks within the HX Stomp, make sure the block you want to control is highlighted and then follow the steps below using the MIDI "Learn" feature. When you press (or double press) a button, the Micro will automatically send its respective MIDI CC message to the Stomp and the Stomp will sync to the Micro.

Block-Bypass.PNG

To toggle effect parameters up/down, follow the steps below to assign a button on the Micro to the effect you choose. When you press (or double press) a button, the Micro will automatically send its respective MIDI CC message to the Stomp and the Stomp will sync to the Micro.

Parameter-Control.PNG


Revision #6
Created Fri, Nov 6, 2020 3:32 PM by Junior Thomason
Updated Fri, Nov 6, 2020 4:06 PM by Junior Thomason